Instructions for Series 2000
1) Roll-Away™ screen
2) Two #6 flat head screws
3) Two Roll-Away™ guides
4) Four #4 flat head screws
guides to roller housing
of guides into the roller housing end-cap stems with the openings
facing each other. (NOTE: the TOP of the guide is the end which
is at least 5" from the nearest pre-punched latch stop. The BOTTOM
end of the guide os 3/4" from the pre-punched latch stop.) Use
the screw hole inside the end-cap stems to mark each guide for
location of the installation screw. Drill a 5/32" hole in
each guide at the marked location. If the guides need to
be shortened trim from the TOP only!
2) Place assembled
unit into window opening
unit by the guides and place into the window frame. To allow
proper operation of the window, the outside edge (window side)
of the guides should be set back 1/8" from the window( standard
draw bar R20 units only). Make sure the Roll-Away™ is properly
aligned and square inside the window frame. With the unit
in place, prior to fastening, test the operation by drawing the
screen down to the sill. Slowly retract the screen back
into the housing and proceed with the installation.
guides at bottom
2 the draw bar of your unit should have latched securely into
the pre-punched stops at the bottom guides. If it did not,
you may need to slip a putty knife under each guide to insure
proper clearence and fit into your window opening. Once
proper clearance has been established, fasten both guides to the
window jamb at the bottom using #4 flat head screws provided.
housing to window frame
for proper alignment, fasten the end-cap stem and the top of each
guide to the window frame using the #6 flat head screws provided.
Check the proper operation of the unit to be sure it latches at
the bottom. Use additional #4 flat head screws provided
to fasten the guides at the mid-point of height if needed.